Pre-Order
Pakendi mõõtmed
47,00 x 19,00 x 30,00 cm
Kogukaal
9,000 kg
Frequently asked questions about the Welding equipment and accessories category
What are Welding equipment and accessories and what are they used for?
Welding equipment and accessories are machines and consumables for welding: inverters (MIG/MMA/TIG), plasma cutters, gas regulators, welding wire and electrodes, magnetic angle holders and safety masks. They are used for bodywork, fabricating metal structures and installation work, chosen by welding type and machine power.
Should I choose a MIG inverter or a Multi (4in1) welder?
Choose MIG (e.g. DNIPRO-M MG-16 or EASY MIG210E) for wire welding thin-to-medium metal. A Multi (4in1) machine is better if you need several processes (MIG/MAG/MMA/TIG) in one unit for diverse workshop tasks.
Which electrodes and wire are suitable for home and professional welding?
For home use common choices are DNIPRO-M electrodes 2.0x250 mm and wire ER70S-6 0.8 mm; for critical structures choose wire/electrodes with the right strength and chemical composition as stated in product specs. Always check compatibility with your machine and welding mode.
Which gas regulator is needed for propane and what should I check?
Use a propane regulator like DR115 or DFR428 with the correct fitting and pressure gauge. Check operating pressure range (DR115: 1–4 bar), connection thread (e.g. 1/4") and whether a fill indicator is included for safety.
Is an inverter welder suitable for car chassis and bodywork?
Yes, inverter models like SPARTUS EASYARC200 200A and STANLEY 51040 160A are suitable for bodywork due to stable current and MMA/MIG functions. Choose a model with enough amps and fine adjustment for thin automotive sheet metal.
Which protective mask and filter should I choose for MIG/TIG welding?
Choose an auto-darkening mask such as the SPARTUS EASY FOX with adjustable shade suitable for MIG/TIG and a reaction time under 1 ms. Ensure the viewing area and shade range suit the welding type and arc intensity.
Do I need magnetic angle holders and which should I choose for assembly?
Magnetic angle holders (DNIPRO-M MW-99, MW-2211, MW-3414) make holding corners and positioning parts easy. Choose by holding force (products range from ~11–34 kg) and shape depending on part size and required angle.
Is the SCHEPPACH PLC 40 plasma cutter suitable for clean sheet metal cutting?
Yes, the SCHEPPACH PLC 40 is designed for cutting sheet and profile metal with a clean edge; it provides quick arc interruption and is suitable for workshop metalwork when used within the product's recommended cutting thicknesses.
Which welding cable and clamp kit should I choose for an inverter?
Choose a kit with sturdy clamps and adequate cable cross-section, such as WS-3216C, rated for the inverter's amperage. Pay attention to cable length and connector types for workplace convenience.